Table of Contents
Advertisement
Ensure that air can flow freely around the housing area.
If the oven is being installed into a fully enclosed built under oven housing
unit it may be necessary to cut a small slot in the top of the plinth fitted under
the unit. Cut a section 400 mm wide and a minimum of 1 5 mm high to allow air to
pass under the unit.
Failure to allow adequate ventilation to the appliance may
result in over heating or damage to adjacent units.
Lift the oven carefully into position on the shelf, taking
care NOT to lift it by the door handle. If you lower the
oven door, you will see 4 screw holes, 2 on each side
of the oven.
The oven should then be secured to the housing by
fitting screws into these holes.
Remember the housing should not be free standing
but secured to the wall and/or
adjacent fittings.
Figure 2
6
How to install your oven
Advertisement
Table of Contents
