Indesit K 642 G/G Instructions For Installation And Use Manual page 6

c) Minimum regulation of the hob burners:
• turn the tap to minimum;
• remove the knob and adjust the regulation screw, which is
positioned in or next to the tap pin, until the flame is small but
steady.
N.B.: in the case of liquid gas, the regulation screw must be
screwed in to the bottom.
• check that the flame does not turn off when you turn the tap
quickly from high to low.
d) Regulating the primary air of the burners:
The primary air of the burners requires no regulation.
Adapting the gas oven to different types of gas
a) Replacing the oven burner nozzle:
• remove the warming drawer;
• in the case of models without warming drawer, remove the
panel "P" as indicated in Fig. A. Open the door, release the
two top inserts by pressing them downwards, and then the
two bottom inserts by pressing them upwards.
• remove the sliding protection "A";
• remove the two screws to dismount the protection "B"; (see
Fig. B);
• remove the screw and then the oven burner "V"(see Fig. C).
Remove the oven door to facilitate this operation.
• unscrew the oven burner nozzle using the special socket
spanner for the nozzles (see Fig. D), or better still a 7 mm
socket spanner, and replace it with a nozzle suited to the
new type of gas (see table 1).
Fig. A
b) Minimum regulation of the gas oven burner with thermostat
•
•
•
•
•
Adapting the gas grill to different types of gas
Replacing the nozzle of the grill burner:
•
•
A B
Fig. B
6
V
Fig. C
(see fig.):
light the burner as described in the paragraph "the oven knob"
of the instruction booklet.
turn the knob to Max for about 10 minutes and then turn the
knob to the Min setting;
remove the knob;
regulate the screw positioned outside the thermostat pin
until the flame is small but steady.
N.B.: in the case of liquid gas, the regulation screw must
be screwed in to the bottom.
check that the burner does not turn off when you turn the
knob from Max to Min and and when you open and close
the oven door quickly.
remove the screw and then slide out the grill burner "V"
(see Fig. E);
unscrew the grill burner nozzle using the special socket
spanner for the nozzles (see Fig. F) or better still a 7 mm
socket spanner; replace the nozzle with a nozzle for the new
type of gas (see table 1).
V
Fig. E
Fig. D
I
Fig. F