Learning Method - Universal Remote Control Automator URC-200 Owner's Manual

Learning Method

The Automator can learn commands from your old
remote controls one-button-at-a-time by following
these simple steps:
Line-up the Automator with your old remote con-
1
trol, head-to-head, one or two inches apart.
Press and hold the MAIN and ENT (Enter) buttons
2
at the same time for approximately three seconds.
The top of the display will show "SETUP". You are
in SETUP mode now.
Note: You have 30 seconds to perform a step while you are
in SETUP mode. If you don't press a button within that time,
the Automator will time out and return to normal operation.
3
Press the LEARN button.
The top of the screen will change to "LEARN".
T h e A u t o m a t o r
10
LEARN
Button