Woods MOW'N MACHINE FZ22K Operator's Manual page 26

ADJUST STEERING HANDLES
1
2
1. 5/16 NC x 1 Whiz bolt
2. 5/16 Flanged lock nut
Figure 14. Steering Handle Adjustment
1. Remove whiz bolt (1) and lock nut (2) from left
steering lever mount.
2. Position steering handle to desired location on
steering lever mount. The top and middle holes are
I
26 Assembly
for taller operators and the middle and bottom
holes are for shorter operators. Do not tighten
hardware at this time. Repeat steps 1 and 2 for
right steering handle.
3. Rotate handles inward. Align handles with one
another. Torque all hardware to 12 lbs-ft. Make
sure handles stay in alignment.
Straight Line Travel
1. Check tire pressure; tires must have equal air
pressure.
2. Check travel; drive forward with both steering
handles full forward at half throttle.
• If travel is not straight, adjust steering handle stop
bolt on opposite side of turn.
DP8
• If power unit turns to the left, raise steering stop
bolt on the right.
• If power unit turns to the right, raise steering stop
bolt on the left.
• For quick adjustments, access stop bolt throught
front cover.
❖
MAN0999 (12/4/2012)