RIDGID R4090 Operator's Manual page 25

OPERATION
TO CHANGE CUTTING WHEEL DEPTH
See Figure 33.
The depth stop limits the wheel's downward travel allowing
the wheel to go below the table enough to maintain full cut-
ting capacities.
 Unplug the saw.
 To adjust the depth, loosen the wing nut located on the
depth stop knob.
 Turn the depth stop knob. Set the wheel to the correct
cutting depth (wheel just below the table surface).
Lower the cutting wheel to the table to check wheel
clearance.
 Tighten the wing nut.
TO CHANGE CUTTING WHEEL ANGLE
(BEVEL)
See Figure 34.
NOTE: A 90° cut has a 0° bevel and a 45° cut has a 45°
bevel.
 Unlock bevel control by lifting the bevel lock lever.
 Standing at the right side of the saw, place the left hand
on the "D "handle and the right hand on the grip.
 Lift the cutting head and move the head to the desired
angle.
 Tighten bevel control by pushing the bevel lock lever
down.
TO ADJUST THE BEVEL INDICATOR
See Figure 35.
 With the cutting wheel at 90°, the bevel indicator should
be pointing to 0°.
 Loosen the screw and position the bevel indicator to point
to 0°. Retighten screw.
 With the wheel at 45°, the bevel indicator should be point-
ing to 45°.
 Loosen the two screws on the scale and adjust the scale
until the bevel indicator points to 45°.
dePth
stoP
winG
nut
BeVel locK
leVer
GriP
BeVel
indicator
25 — English
unlocK
locK
BeVel
screw scale
d-handle
Fig. 33
d-handle
Fig. 34
screw
Fig. 35