RIDGID R4090 Operator's Manual page 13

ASSEMBLY
ASSEMBLING THE WSUV™ WET SAW
UTILITY VEHICLE / LEG STAND
See Figure 7.
Many of the WSUV™ / leg stand parts are movable. All
hardware must be tightened securely but not so tight that
the utility vehicle / leg stand won't open and close. For easier
assembly, match letter to letter.
 Place a curved spacer over the end of the lower brace (F).
 Insert a hex head bolt and small flat washer at the bottom
of the right outer tube (G) and into the lower brace (F).
Tighten securely. Repeat for the other side.
 Place a carriage bolt through the center hole in the outer
tubes (G) then place a spacer on the bolt.
 Slide the bolt/spacer into the inner leg assembly (G) and
secure in place using a lock nut. Do not overtighten.
Repeat for the other side.
 Place the center brace on top of the inner leg assembly
(curve side up) with the stop pin under the pedal assembly
latch.
NOTE: The stop pins rest on top of inner leg assembly.
left
uPPer
tuBe
carriaGe
Bolt
lower
Brace
hex head
Bolt
riGht outer
tuBe
locK
nut
sPacer
stoP
Pin
flat washer,
left
MediuM
outer tuBe
 Insert a carriage bolt through the top hole of the inner leg
assembly then slide a spacer on the bolt. Repeat for the
other side.
 Slide the center brace onto the bolt (F) and secure in
place using a lock nut. Repeat for the other side.
 With the curve handle turned downward, secure the up-
per tubes (E and H on the right side, and A and D on the
left side) to the leg stand using carriage bolts, spacers,
and lock nuts. The tube with the diverter valve attached
should be placed on the left side of the leg stand.
 Locate the lock nut and two flat washers.
 Slide the flat washer, wheel, and flat washer onto the
axle through the hole in the center of the wheel. Secure
in place using lock nut.
 Repeat with the second wheel.
riGht uPPer
tuBe
wheel
locK
nut
13 — English
inner leG
asseMBlY
center
Brace
axle
flat washer,
larGe
Fig. 7