RIDGID R4090 Operator's Manual page 15

ASSEMBLY
INSTALLING WATER SUPPLY VALVE
See Figure 10.
 Unscrew the connector from the water supply valve and
remove the mounting bracket.
 Align holes in mounting bracket with holes on top of
upper tube and secure in place using screws and nuts.
 Slide the threaded end of the valve into the mounting
bracket hole and secure using the connector.
INSTALLING CLEAR TUBES AND CLEANING
NOZZLE
See Figure 11.
NOTE: Hose clamps secure clear tubes to valves, connec-
tors, etc. To attach a hose clamp, squeeze the ends of the
clamp together then slide the clamp over one end of a short
clear tube. Once the tube has been attached to a valve, con-
nector, etc., squeeze the clamps ends together and slide the
clamp over the tube covering the connector.
 Grasp the diverter valve firmly then push the end of the
short clear tube over the left connector. Secure with a
hose clamp.
 Slip the tube onto the valve assembly in the saw arm by
pushing the tube over the connector. Secure with a hose
clamp. Attach the clear tube to leg stand using the tube
clips on top of the leg stand.
 Holding the diverter valve, connect the long clear tube
(with the cleaning nozzle) to the right side of the diverter
valve by pushing the tube over the connector. Secure
with a hose clamp. Store the nozzle in the cleaning nozzle
storage.
water suPPlY
ValVe
clear
tuBe
connector
clear
tuBe
ruBBer
Boot
water
suPPlY
ValVe
15 — English
nuts
screws
connector
diVertor
ValVe
hose
claMP
cleaninG
noZZle
storaGe
inner leG
asseMBlY
Fig. 10
clear tuBe
with cleaninG
noZZle
water
fill
line
Fig. 11