Icom IC-RX7 Instruction Manual page 17

!2 STATUS INDICATOR
Shows the receiver's status such as "HOLD," "SCAN,"
"SEARCH" or "MEMORY."
!3 KEY LOCK INDICATOR (p. 73)
Appears when the key lock function is activated.
!4 DIAL STATUS INDICATOR (p. 75)
➥ " DIAL" appears when [DIAL] is assigned as frequency
control.
• In this case, [r]/[s] keys are activate for volume control.
➥ " VOL" appears when the [DIAL] is assigned as volume
control.
• In this case, [r]/[s] keys are activate for frequency control.
!5 AUTO POWER OFF INDICATOR (p. 82)
Appears when the auto power OFF function is in use.
!6 TONE SQUELCH INDICATOR (pgs. 76, 77)
Available only when FM mode is selected.
➥ " TSQL" appears while the tone squelch function is in
use. (p. 124)
➥ " TSQL-R" appears while the reverse* tone squelch
function is in use. (p. 124)
➥ " DTCS" appears while the DTCS squelch function is in
use. (p. 124)
➥ " DTCS-R" appears while the reverse* DTCS squelch
function is in use. (p. 124)
➥ " S" appears with the "TSQL" or "DTCS" indicator
while the pocket beep function
in use. (p. 125)
*: Reverse tone squelch or reverse DTCS squelch closes when
the signal is received with matched tone or DTCS.
is
(with CTCSS or DTCS)
PANEL DESCRIPTION
!7 VOICE SQUELCH CONTROL INDICATOR (p. 83)
Appears when VSC (Voice squelch control) function is in
use.
!8 DUPLEX INDICATOR (pgs. 74, 75)
" +DUP" appears when plus duplex, "–DUP" appears when
minus duplex is selected.
!9 RF GAIN INDICATOR (p. 72)
"RF" appears when the RF gain is adjusted other than
"MAX."
@0 ATTENUATOR INDICATOR (p. 73)
Appears when the RF attenuator is in use.
2
1
2
3
4
5
6
7
8
9
10
11
12
13
14
15
16
17
18
19
9