ATEN Master View CS-9134 User Manual page 22

w
F2 SCAN:
Pressing [F2] initiates Quick View Scanning, in which the OSD cycles
through all the ports that have been selected for this with the QV feature (see
F4 QV, below). It stays on each port for the amount of time set with the Scan
Duration setting under the F6 SET function (see p. 20). When you want to
stop at a particular location, press the [Spacebar] to stop scanning.
Note: 1. If the scanning stops on an empty port, or one where the computer
is attached but is powered Off, the monitor screen will be blank,
and the mouse and keyboard will have no effect. After the Scan
Duration time is up, the Scan function will move on to the next port.
2. As each port is accessed, an
displayed on the console monitor to indicate that it is being
accessed under Quick View Scan Mode.
w
F3 LIST:
This function lets you broaden or narrow the scope of which ports the OSD
lists. On the submenu that appears, an icon of a pointing finger indicates the
currently selected choice. To change a setting, move the highlight bar to the
choice you want, then press [Enter]. An explanation of the settings is given in
the table below:
Choice
ALL Lists the Port ID numbers and Names (if names have been
specified - see F5, below), of all the ports on the installation.
QVIEW Lists only the ports that have been selected for Quick View
scanning (see F4, below).
POWERED ON + Lists only the ports that have been selected for Quick View
QVIEW scanning (see F4, below), and that have their attached
computers Powered On.
QVIEW + NAME Lists only the ports that have been selected for Quick View
scanning (see F4, below), and have been assigned names
(see F5, below).
NAME Lists only the ports that have been assigned names (see F5,
below).
POWERED ON Lists only the ports that have their attached computers
Powered On.
18
S appears in front of the Port ID
Meaning
CS-9134 / CS-9138 User Manual
2001-05-21