Cs-9138 Front View - ATEN Master View CS-9134 User Manual

CS-9138 Front View

K/M RESET
1. Port Selection Switches
Press a switch to access the computer attached to the corresponding port.
M
Pressing Buttons 1 and 2 simultaneously for 3 seconds performs a Key-
board and Mouse reset.
M
Pressing Buttons 7 and 8 simultaneously starts Auto Scan Mode.
2. Port LEDs
The Port LEDs are built into the Port Selection Switches. The upper ones are
the On Line LEDs; the lower ones are the Selected Port LEDs:
On Line: Lights GREEN to indicate that the computer attached to the
corresponding port is up and running. If the LED is flashing, it
indicates that the Port is being used for cascading to another
Master View switch.
Selected: Lights ORANGE to indicate the currently selected port. The LED
is steady under normal conditions, but flashes when its port is
accessed under Auto Scan mode.
3. Sound Opening
System sounds (beeps, etc.), are emitted from this opening.
4. Reset
Use a thin object (such as the end of a paper clip, or a ballpoint pen), to
press this recessed switch in to initiate a warm reset. If the switch is kept in
for longer than three seconds, a cold reset takes place.
5. Power LED
Lights BLUE to indicate that the Master View CS-9138 is receiving power.
6
1
AUTO SCAN
2 3
CS-9134 / CS-9138 User Manual
2001-05-21
4 5