Table of Contents
Advertisement
File system is not correct.
Use IS09660 level 1,2 or JOLIET or Romeo or
APPLE ISO file system.
MP3/WMAJAAC files are not
Use MP3IWMAJAAC files encoded properly.
encoded properly.
~
Reset
button
~
~
~,
Use IS09660 level 1,2 or JOLIET or Romeo or
APPLE ISO file system.
Use MP3/WMAJAAC files encoded properly.
Write MP3IWMAJAAC files onto the disc properly.
1. Turn down sound volume. Function can also be
restored by turning the power off and on again.
(Speaker volume is reduced automatically when
the speaker protection circuit operates).
2. If the sound is muted again, consult our service
department.
Replace with a compact disc with no scratches.
Wipe the dirt off with a soft cloth moistened with
cleaning alcohol.
Clean the compact disc with a soft cloth.
Turn off the power, then press
the [OPEN] button and remove
the DCP.
Press the reset button for about
2 seconds with a thin rod.
1. Turn the unit off.
2. Remove all wires attached to the power antenna
lead. Check each wire for a possible short to
ground using an ohm meter.
3. Turn the unit back on.
4. Reconnect each amplifier remote wire to the power
antenna lead one by one. If the amplifiers turn off
before all wires are attached, use an external relay
to provide remote-on voltage (excessive current
required).
Consult your store of purchase.
Replace with a fuse of the same amperage. If the fuse
blows again, consult your store of purchase.
MP3IWMAJAAC files are
absent in a disc.
Compact disc is heavily
scratched or warped.
Files are not recognized as
an MP3IWMAJAAC file.
Water droplets may form on
Let dry for about 1 hour with the power on.
the internal lens when the car
is parked in a humid place.
File system is not correct.
Compact disc is dirty.
DCP or main unit connectors
are dirty.
The speaker protection circuit
is operating.
The microprocessor has
malfunctioned due to noise,
etc.
Incorrect wiring.
- Power antenna lead is
shorted to ground or
excessive current is required
for remote-on the amplifiers
or power antenna.
Sound is cut or
skipped.
Noise is
generated or
noise is mixed
with sound.
No sound output
when operating
the unit with
amplifiers or
power antenna
attached.
Power does not
turn on.
(No sound is
produced.)
DXZ575USB
33
Advertisement
Table of Contents
