Impex Olympic Cage Owner's Manual page 10

STEP 2 (See Diagram 2)
A.) Attach the Seat Bracket (#36) to the pivot on the Main Frame (#32). Attach the two
Backrest Supports (#38) to the Seat Bracket. Align the holes and secure them together
with one M12 x 8 ½" Allen Bolt (#89), two Ø 1" Washers (#81), and one M12 Aircraft Nut
(#83). Insert the Seat Bracket into the open slot on the Main Frame and use the T-shaped
Lock Pin to secure at desired height.
B.) Attach the Incline Support (#37) to the middle side-holes on the Backrest Supports (#38).
Secure it with one M12 x 8 ½" Allen Bolt (#89), two Ø 1" Washers (#81), and one M12
Aircraft Nut (#83). Place the other end of Incline Support to selected slot on the Main
Frame to obtain desired incline. Do not over tighten the Nut and Bolt. Make sure the
Backrest Board and Incline Support are able to swivel.
C.) Insert the Foam Tube Assembly (#40) into the top opening on the Front Support (#34).
Secure it with the T-shaped Lock Pin (#42) at desired height.
D.) Insert the Foam Tube (#41) halfway through the hole on the Foam Tube Assembly. Push
two Foam Rolls (#51) onto the Foam Tube from both ends. Plug two Foam Roll End Caps
(#66) into the ends.
9
DIAGRAM 2