Assembly Instructions - Impex MARCY MWM 800 Owner's Manual

ASSEMBLY INSTRUCTION
Tools Required to Assemble the Machine: Two Adjustable Wrenches, two Allen
Wrenches, and one Flat Head Screwdriver
NOTE: It is strongly recommended two or more people assembling this machine to
avoid possible injury.
STEP 1 (See Diagram 1)
A.) Connect the Main Base Frame (#2) and Front Base (#3) to the Front Stabilizer (#5).
Align the holes then secure them with two 3/8" x 3" Carriage Bolts (#69),
Washers (#77), and 3/8" Aircraft Nuts (#74).
B.) Attach the Rear Stabilizer (#1) to the Main Base Frame. Secure it with one Bracket
(#26), two 3/8" x 3" Carriage Bolts (#69),
(#74).
C.) Attach the Vertical Beam (#4) to the Main Base Frame (#2). Secure it with two 3/8" x 3"
Carriage Bolts (#69),
D.) Over the two holes on the Rear Stabilizer (#1), stack up two Round Rubber Bumpers
(#40), two Guide Rod Sleeves (#7), then two Round Rubber Bumpers (#40) in
sequence. Align the holes then insert two Guide Rods (#13) all the way down into the
Rear Stabilizer (#1).
E.) Slide the Weight Holder (#8) from the top onto the two Guide Rods.
F.) Place the Upper Frame (#6) onto the Vertical Beam (#4) and the two Guide Rods (#13).
Secure the Upper Frame to the Guide Rods with two 3/8" x 1" Allen Bolts (#63) and
3/8" Washers (#77). Secure the Upper Frame to the Vertical Beam (#4) with two 3/8" x
3" Carriage Bolts (#69),
G.) Attach the Olympic Sleeves (#44) to the Weight Holder (#8). Attach the
Clips (#48) onto the Olympic Sleeves. Please note that we also provided two
Spring Clips in case the
H.) Carefully tip over the machine to its side. Secure the bottom of the two Guide Rods to
the Rear Stabilizer (#1) with two 3/8" x 1" Allen Bolts (#63) and
3/8" Washers (#77), and 3/8" Aircraft Nuts (#74).
3/8" Washers (#77), and 3/8" Aircraft Nuts (#74).
1" standard plates were used.
8
3/8" Washers (#77), and 3/8" Aircraft Nuts
3/8"
2" Spring
1"
3/8" Washers (#77).