Encryption Mode And Key - Motorola PTP 500 Series User Manual

Motorola recommends the following process for entering new license keys and minimizing
service outage:
1. Open two browsers, one for each end of the link
2. Navigate to the 'License Key' data entry page for each end of the link
3. Enter the license keys and click the 'Validate license key' button at each end of the
link. This will allow the software to validate the license key prior to the system reset.
(DO NOT CLICK ARE YOU SURE POPUP DIALOG)
4. When both license keys have been successfully validated, confirm the reboot for both
ends of the link. The software is designed to allow five seconds so that a user can
command both ends of the link to reset before the wireless link drops.
The link will automatically re-establish.

13.3.2 Encryption Mode and Key

Entering the license keys only does not initialize AES link encryption. Link encryption can only
be enabled via the Configuration or Installation Wizard pages. Motorola recommends that the
Configuration page Figure 123 be used to configure AES link encryption.
199
13 AES Encryption