Fuses; Check The Safety System; Checking The Engine's Cooling Air Intake; Checking And Adjustment Of The Cutting Unit's Ground Pressure - Jonsered FR 2213 RA Operator's Manual

Fuses

The main fuse is placed in a detachable holder under the
battery case's cover, in front of the battery.
Type: Flat pin, 15 A.
Do not use any other type of fuse when replacing.
A blown fuse is indicated by a burnt connector. Pull the fuse
from the holder when replacing.
The fuse is there to protect the electrical system. If it blows
again shortly after replacement, it is due to a short circuit,
which must be fixed before the machine can be put into
operation again.

Check the safety system

The machine is equipped with a safety system that prevents
starting or driving under the following conditions.
The engine can only be started when:
• The cutting deck is raised and the parking brake is
applied.
The engine should stop when:
• The cutting deck is lowered and the driver rises from the
seat.
• The cutting deck is in its raised position, the parking brake
is not applied and the driver rises from the seat.
Check daily to ensure that the safety system works by
attempting to start the engine when one of the conditions
above is not met. Change the conditions and try again.
Checking the engine's cooling air
intake
Clean the air intake grille in the engine cover behind the
driver's seat.
Open the engine cover.
22 –
English
Maintenance
Check that the cooling intake is free from leaves, grass and
dirt.
Check the air duct, located on the inside of the engine cover,
ensure it is clean and does not rub against the cooling air
intake.
A blocked cooling intake will interfere with the cooling of the
engine, which can damage the engine.
!
Checking and adjustment of the
cutting unit's ground pressure
To achieve the best cutting results the cutting unit should
follow the underlying surface without pressing too hard
against it. Pressure is adjusted using a screw and spring on
each side of the Rider.
1 Check the air pressure in the tyres 60 kPa / 0.6 bar / 9 PSI.
2 Place a set of bathroom scales under the cutting unit's
frame (front edge) so that it rests on the scales. If
necessary a block can be placed between the frame and
scales so that the support wheels do not bear any weight.
3 Adjust the cutting unit's ground pressure by screwing the
adjuster screws, which are located behind the front
wheels on both sides, in or out. The ground pressure
should be between 12 and 15 kg and the springs evenly
tensioned.
WARNING! The cooling air intake rotates
when the engine is running. Mind your
fingers.