Table of Contents
Advertisement
VLI31 Fireplace Insert
n using the Mounting Base
The transmitter comes with a mounting base which allows
you to hang the transmitter on the wall.
1. Secure the mounting base
on the wall with supplied
screws. For best viewing
angle, make it the same
height as your eyes.
. Hang the transmitter on the
hook of the mounting base,
then push down so the
transmitter is flush to the
mounting base.
Symptom
1. Battery icon on LCD on transmitter
ies
. LCD display is blank
place
3. LCD display shows "funny" display
ting
mitter" section).
4. Appliance does not come on
below 99 degrees.
5. Blower is not on after the fireplace is
speed
you desire.
34
tOuch ScReeN ReMOte cONtROL OPeRAtION
Figure 39
FP2674
TROUBLESHOOTING
mounting base
causes
1. Low Battery
. The transmitter did not match
with the receiver
3. Transmitter measures temp-
erature exceeding 99 degrees
4. Distance between the transmitter 1. Make sure the opening distance is
and receiver is more than 30 feet
5. Blower setting is off
6. Blower delay setting is set too
Action
1. Replace batteries. Change batter-
every 6 months.
. Check battery installation or re-
3. Reset the transmitter (see "Reset-
1. Make sure the transmitter has
learned to the receiver.
1. Move transmitter to a cooler place
and wait until temperature drops
Fahrenheit and shows "HI" on
less than 30 feet.
1. Press FAN key to select Fan
turned on
1. Press and hold FAN key to set
batteries.
the Trans-
LCD
83D4009
Advertisement
Table of Contents
