Table of Contents
Advertisement
Inspection and Shipping Claims
Check for shipping damage upon receipt of the spa. Jacuzzi Whirlpool Bath is not responsible for damage to the spa sustained
during shipping. If damage is evident before unpacking, see instructions regarding shipping claims on the outside of the carton and
immediately file a claim with the carrier.
Once the spa has been removed from the carton and before it is permanently installed (see below on this page for unpacking
instructions), check the spa completely for damage. Fill the shell with water and operate the system (see Operating Instructions) to
check for leaks which have resulted from shipping or handling. All Jacuzzi Whirlpool Bath spas are factory tested for proper operation
and water tight connections prior to shipping. If leaks or other problems are detected, immediately notify your Jacuzzi Whirlpool Bath
dealer or Authorized Service Agent, or call Jacuzzi Whirlpool Bath, (510) 938-7070 or (510) 938-7411 for Warranty Service.
Note: Damage or defects which could have been discovered and repaired prior to installation and which are claimed
after final installation of the spa, are excluded from our warranty.
Unpacking
1.
Remove the outer carton by disassembling bracing
side panels.
2.
Remove the equipment pack from the pallet by removing
bolts and nuts securing the equipment pack base to the
pallet.
3.
The spa should be moved to its final location on a dolly
in its upright position while still attached to its shipping
pallet.
4.
When the spa has been moved to its final location,
preferably a concrete pad or other supported surfaces,
place a 4 x 4 x72" wooden block beside the base side
(bottom end) of the spa so it is parallel with the pallet.
5.
Tip the spa over onto its bottom with the block supporting
the spa. Do not handle the spa by its plumbing;
handle it by the shell only.
6.
Detach the spa from the shipping pallet by removing the
bolts from the pallet.
7.
Leave the remaining plastic sheet attached to the spa
shell to keep the shell clean and free from debris during
installation.
8.
Before installation begins, remove and retain the owner's
packet from the product accessory box. This packet
contains the Specifications and Installation Instructions,
and Operating Instructions. The accessory box also
contains filters cartridges, skimmer baskets, check valves,
and the equalizer tube assembly with installation hard-
ware and connections to be installed on the equipment
pack. Set aside the filter cartridges in a dry place until it
is time to set up the spa equipment. Read all instructions
contained in both manuals before beginning installation.
9.
Record the spa and equipment pack serial number on
the inside front cover of the Owner's manual. (See
illustration on page 2 for the serial number location.)
10. When unpacking optional equipment, keep enclosed
literature for owner's reference.
INSTALLATION
and
3
FIBERBOARD
PALLET
4 X 4 X 72"
REMOVE
BLOCK
BOLTS
BOLTS
4 X 4 BLOCK
Advertisement
Table of Contents
