Operation Instructions; Equipment Set-Up - Jacuzzi The Cirrus IG Owner's Manual

Equipment Set-Up

Important: Your spa equipment pack must have two professionally installed 230 VAC 15 AMP electrical circuits from your
house electrical panel. Additional power will be required for optional equipment, such as heater, air blower, or chlorinator.
A proper ground wire run to a ground approved by your local building or electrical inspector is also required. Make sure the
equipment is properly bonded as instructed in Installation Instructions.
1. Turn OFF all power to the equipment pack by turning off
circuit breakers at the main electrical service panel.
Warning! Turn off all power to the equipment pack
before priming, draining the spa, or performing any
equipment maintenance.
At no time should the whirlpool or filter pump motors
be activated until the pumps are primed and the spa is
filled with water to its normal operating level. Running
the pump dry will cause irreparable damage to the
pump, and the warranty will become void.
EQUIPMENT PACK
SUCTION
EQUALIZER
TUBE ASSEMBLY
HOSE BIB
REDUCER BUSHING
OPERATION
CLEAR PIPE (2)
BOLT (8)
(DOTTED LINES INDICATE PARTS
TO BE INSTALLED ON SITE.)
2. Turn on the circuit breakers at the service panel.
3. Follow Priming Procedure, I or II, depending on your
installation type, and check pipes, pumps, and fitting for
leaks.
4. Set thermostat at heater (see heater manufacturer's
operating instructions.)
5. Test for proper water chemistry; then add treatment
chemicals to ensure proper levels. See "Water Quality"
section for details.
2" PVC ELL
AIR VENT VALVE (2)
PUMP FLANGE
GASKET (2)
PUMP FLANGE (2)
15