Installation Instructions; Inspection And Shipping Claim; Unpacking - Jacuzzi PALIO Owner's Manual

Installation Instructions

Inspection and Shipping Claim

Check for shipping damage upon receipt of the spa. Jacuzzi Whirlpool Bath is not responsible for damage to the
spa sustained during shipping. If damage is evident before unpacking, see instructions regarding shipping claims on
the outside of the carton and immediately file a claim with the carrier.
Once the spa has been removed from the carton and before it is permanently installed (see below on this page
for unpacking instructions), check the spa completely for damage. Fill the shell with water and operate the system
(see Operating Instructions) to check for leaks which may have resulted from shipping or handling. All Jacuzzi
Whirlpool Bath spas are factory tested for proper operation and water tight connections prior to shipping. If leaks or
other problems are detected, immediately notify your Jacuzzi Whirlpool Bath dealer or Authorized Service Agent, or
call Jacuzzi Whirlpool Bath, (510) 938-7411, or (510) 938-7070 for Warranty Service.
Note: Damage or defects which could have been discovered and repaired prior to installation and which are
claimed after final installation of the spa, are excluded from our warranty.

Unpacking

1. Remove the outer carton by cutting the bands and
lifting the cover and the sides. Leave the protective
plastic sheet on the spa until installation begins. This
sheet can be re-used to protect the finish from dam-
age and debris during construction.
2.
Lift the spa from the carton (approximate weight 450
lbs.) and set it in place on the patio, deck, or position
of intended use. Do not handle the spa by its
plumbing; handle it by the bottom of the skirt
only.
3. If, after having been removed from the carton, the spa
must be turned over onto its side to move, make sure
the surface of the cart of dolly on which it is place is
large enough to support the product weight and could
be damaged if allowed to do so. (See illustration on
this page, lower right.)
Before installation begins, remove the owner's packet
from the Accessory package. This package contains
the Warranty Card and the Owner's Manual. Record
the spa serial number on the inside front cover of this
manual and on the warranty card. (See the illustration
on page 2 for the serial number location.)
INSTALLATION
Important: Read complete instructions before
beginning installation.
SPA RIM
CART OR DOLLY
SURFACE MUST SUPPORT
SPA RIM AND BASE OF SKIRT
SKIRT BASE
3