Installation; Inspection And Shipping Claim; Positioning Your Spa; Electrical Requirements - Jacuzzi Aero Select Owner's Manual

INSTALLATION

Inspection and Shipping Claim

Check for shipping damage upon receipt of the spa.
Jacuzzi Whirlpool Bath is not responsible for damage to
the spa sustained during shipment. If damage is evident
before unpacking, refer to instructions regarding ship-
ping claims on the outside of the carton and immediately
file a claim with the carrier.
Once the spa has been removed from the carton
and before it is permanently installed, check the spa
completely for damage. Fill the shell with water and
operate the system (refer to Operating Instructions) to
check for leaks which may have resulted from improper
shipping or handling. All Jacuzzi Whirlpool Bath spas
are factory tested for proper operation and water tight
connections prior to shipment. If leaks or other problems
are detected, immediately notify your Jacuzzi Whirlpool
Bath dealer, Authorized Service Agent, or call Jacuzzi
Whirlpool Bath, (800) 288-4002 for Warranty Service.
NOTE: Damage or defects which could have been
discovered and repaired prior to installation and
which are claimed after final installation of the spa,
are excluded from our warranty.

Positioning Your Spa

Because your spa is portable, you can locate it just
about anywhere you wish—on a deck, patio, or even
indoors. Just be sure to position it above ground in an
area with good drainage and on a level, continuous
surface which can support the weight of the spa when
filled with water and people. You must also provide
access to the spa's equipment for service and general
maintenance. See specifications sheet for minimum
service access requirements.

Electrical Requirements

Your Select (except Alexa) Series spa requires a
230 VAC, 50 AMP, 4-wire, grounded type GFCI pro-
tected electrical service with copper conductors, and
must be in a separate circuit having no other appliance
connected in that circuit. If you do not have this kind of
circuit, a qualified electrician should install the neces-
sary wiring. A wiring diagram is provided on the inside
cover of the electrical control box. Inadequately sized
wiring may cause the unit to malfunction and bring about
permanent damage to the spa's electrical system. The
circuit must also have a ground wire in order to take
advantage of the designed-in safety features of the spa.
A bond wire must also be used. Bond according to
procedure described on the next page.
WARNING: Without proper grounding and bonding,
a system malfunction may cause fatal shock.
5