Electrolux EVE916BA User Manual page 40

40
INSTALLATION OF THE EFE956BA & EFE916BA
Cabinet construction for freestanding installation
600mm minimum
vertical clearance from
combustible surfaces
600mm
895mm
The freestanding type installation uses the appliance as
supplied, and can be fitted in between cabinets, with
cabinets on one side or without adjacent cabinets. There
is no clearance requirement to adjacent side cabinets.
Installation of anti-tilt brackets and hook
• T he anti-tilt brackets must be secured to the floor at
rear of cavity with an appropriate fastener according to
dimensions in diagram
• T he hook is to be secured to the back wall in the
location shown above with an appropriate fastener
capable of withstanding a 10kg load
• C onnect services to the appliance prior to placing
into cavity
600mm
Gas Hob 910mm
(adjustable 910-930mm)
Induction Hob 906mm
(adjustable 906-926mm)
Hole location for
hook installation
425mm
376mm
900mm
minimum
Chain
15mm height of
trivet from hob
Anti-tilt Bracket
To ensure cooker stability, the anti-tilt brackets must be
installed, and the end of chain attached to the appliance
must be placed onto the hook attached to the rear wall.
measurements are to be adjusted to
account for the thickness of any skirting
board or tiles coming between the back
of the appliance and the wall
• T o locate appliance, slide into cavity ensuring the rear
left and right foot of appliance are captured by the
anti-tilt brackets
• B efore the appliance is fully pushed into position,
place the chain attached to the rear of appliance
onto the wall hook
Wall hook
755mm
900mm