Editing Patches; Scrolling Text Display - E-Mu X board25 Owner's Manual

Basic Operations

Editing Patches

The editable program functions are accessed using the labelled keyboard keys.
To Edit a Patch:
1. Press the Edit button. The Edit LED illuminates.
2. Select the desired Function to be edited by pressing one of the marked key-
board keys. (The Velocity Curve is being edited in the example below.)
3. Adjust the value of the parameter using the data slider or using the numeric
keyboard keys. The Enter button will be flashing.
4. Press Enter to confirm the operation. Press Home to cancel the operation.
5. Remember to Store the Patch or your changes will be lost when the X Board is
turned off. See page 22.
DATA ENTRY / MASTER VOLUME
3
Semitone Semitone
Transpose Transpose

Scrolling Text Display

In the Edit menu, the 3-digit LED serves double duty as a scrolling text display.
When you first press the Edit button, the word "SELECt" scrolls continuously across
the display, prompting you to select an edit parameter by pressing one of the
labelled keys. After an edit parameter is selected, the current value of the parameter
is displayed. After a short delay, the edit parameter name begins scrolling. If you
enter a value, the display stops scrolling.
X Board
1
Edit
Store
4
2
Vel Vel 16-Ch. 16-Ch. Latch Latch Latch Latch
Curve Curve CC CC Low Low High High
Select Select Number Number Note Note Note Note
Step: 1. Press Edit
2. Select Function
3. Adjust Value
4. Press Enter
Save CC Save CC CC Send CC Send PGM Send PGM Send Bank Bank
Val in Val in On On On On Sel Sel
Patch Patch Recall Recall Recall Recall MSB MSB
Bank Bank Send Send Aftertouch Aftertouch
Sel Sel Prog Prog
LSB LSB Change Change
23