Note Latch Mode Settings; Save Controller Values In Patch; Send Controller Values On Patch Recall; Velocity Curve Select - E-Mu X board25 Owner's Manual

E-MU X Board Control

Note Latch Mode Settings

Save Controller Values in Patch

If this parameter is Off, the existing continuous controller settings are retained.

Send Controller Values on Patch Recall

When this parameter is set to On, the stored settings of the 16 Controller Knobs,
the Mod Wheel and the Footswitch/Footpedal will be transmitted when the Patch is
selected. When set to Off the continuous controller settings will not be transmitted
when the patch is selected.
Note: Pressing the Snapshot button will immediately send the stored controller
values.

Velocity Curve Select

This function selects one of the eight velocity curves to customize the velocity
response of the keyboard. Select a synthesizer preset that has velocity programmed
(such as a piano), then choose a curve that gives you the best control.
Click on an image to select the desired velocity curve for the patch. See page 27 for
descriptions of the curves.
E-MU Systems
This section allows you to program the high and
low keys for latch mode, as described on page 25.
You can also turn latch mode on or off by pressing
the amber-colored button. Note that you cannot
set a low key number higher that the high key, or a
high key number lower than the low key.
When this parameter is set to On, the
position of the 16 knobs, Mod Wheel
and Footswitch/Footpedal settings will
be saved with the Patch.
38