Back Panel Description - E-Mu X board25 Owner's Manual

Back Panel Description

BACK PANEL DESCRIPTION
1
1. Footswitch / Footpedal Input
This jack accepts either a footswitch or continuously variable footpedal. The
default setting is for a footswitch. To use a footpedal, see page 30.
Footswitch - Accepts either a normally-open or normally closed, momentary
Footpedal - Accepts most standard footpedals with a stereo plug. See the wiring
2. MIDI Output
Outputs note and controller MIDI data from the X Board. This jack can also be
used as a MIDI interface from a computer software application. See page 30.
Use a standard MIDI cable to connect the X Board to the MIDI input jack of
other MIDI devices.
3. USB
Connects X Board to your computer via the supplied USB cable. The USB
connection provides two-way communication when connected to the
computer and also supplies power to the X Board. Always connect to the USB
jack on the computer itself and NOT an unpowered USB connection that
may be present on your computer keyboard or other USB peripheral.
4. 6 Volt DC Power
This jack allows the X Board to be powered from a standard 6VDC Adapter
(positive tip) when not connected to the computer via USB.
5. On/Off Switch
This switch turns the X Board on or off whether powered via USB, AC Adapter,
or batteries.
X Board
2
footswitch. The X Board auto-senses the polarity on power-up.
diagram shown on page 52 for pedal wiring specifications.
3 4 5
19