Power Wheels H4435 Owner's Manual With Assembly Instructions page 16

F
28
• Fit the spacers between the upper holes of the brush guard and the
front end of the vehicle
• Insert two #8 x 4" screws through the two upper holes in the brush
guard, through the spacers and into the front end of the vehicle
Tighten the screws.
16
A
Spacers
B #8 x 4" Screws
.
A
ASSEMBLY
Holder
29
• Using safety scissors, cut the plastic tie holding Backpack in the
holder. Remove Backpack from the holder.
Note to Retailer: Do not remove the plastic tie. Simply lift Backpack
from the holder and assemble the holder to the top edge of the
.
B
vehicle. Replace Backpack in the holder.
• Fit the holder to the top edge of the vehicle as shown.
• Insert two #10 x 1" screws into the holder. Tighten the screws.
Backpack
30
• Fit Backpack into the holder.
Backpack
Holder
H4435pr-0921