Power Wheels H4435 Owner's Manual With Assembly Instructions page 12

F
Wheel
(Indented Side First)
Hubcap
(Pointed Side First)
.437
Cap
Nut
12
.437"
• Turn the vehicle upside down on a flat surface.
• Fit a washer, bushing (ring side first), wheel (indented side first) and
hubcap (pointed side first) onto one of the front axles.
• Fit a .437 cap nut onto the end of the front axle.
• Tap the cap nut with a hammer to secure the cap nut on the front
axle. Pull on the cap nut to be sure it is secure.
• Repeat this procedure to assemble the other washer, bushing, wheel,
hubcap and .437 cap nut to the other front axle.
13
• Turn the vehicle upright.
• Fit both tabs on the front end of the seat into the slots in the vehicle.
12
Washer
Bushing
Front Axle
(Ring Side First)
BOTTOM VIEW
Bushing
Ring
Side
Seat Tabs
FRONT VIEW
ASSEMBLY
14
• Insert a #10 x 1" screw into the back edge of the seat. Tighten
the screw.
Hole
15
Slots
• Position the roll bar so that it bends toward the back end of
the vehicle.
• Insert and "snap" the roll bar into the large holes in the top side of
the vehicle, as shown.
• Pull up on the roll bar to be sure it is secure.
Roll Bar
Hole
H4435pr-0921