Lock Modes (L1-L2); Selecting The Filtration/Heating Mode - Jacuzzi J-315 Owner's Manual

11.3 Lock Modes (L1-L2)

These modes are designed for use during spa service or to prevent unauthorized
use.

11.4 Selecting The Filtration/Heating Mode

Press and hold both control panel WARMER (
the same time, then release. Then press either WARMER (
button to select filtration/heating mode F0-F6 or lock modes L1-L2 below:
Standard Filtration/Heating Modes
F0 5 minutes of filtration per day (one 5 minute "Blow-Out"
cycle every 24 hours to purge all plumbing lines)
F1 1 hour of filtration per day (one 30-minute cycle every 12
hours); This is the factory default setting.
F2 1.5 hours of filtration per day (one 30-minute cycle every 8
hours)
F3 2 hours of filtration per day (one 30-minute cycle every 6
hours)
Economy Filtration/Heating Modes
F4 1 hour of filtration/heating per day (one 30-minute cycle
every twelve hours)
F5 1.5 hours of filtration/heating per day (one 30-minute cycle
every eight hours)
F6 2 hours of filtration/heating per day (one 30-minute cycle
every six hours)
Lock Modes
L1 Lock Out: disables all spa functions to permit filter
cleaning.
L2 Lock Mode: disables the jets and light buttons to prevent
unauthorized use of spa. Filtration/heating cycle will
continue to operate as programmed in this mode. The temperature display
flashes when this function is enabled. EXAMPLE: the "F3" filtration/heating
cycle was enabled prior to choosing lock mode. The spa continues to perform the
"F3" cycle until lock mode is canceled, allowing another cycle to be selected.
To set a time for the first filtration/heating cycle, simply turn power on to the spa
two minutes prior to the desired time. EXAMPLE: If you desire your first filtration/
heating cycle to begin at 10:00 AM turn off power to the spa and turn it back on again
at 9:58 AM. Note: start time is approximate and may vary slightly from day to day.
J-300 Series
) and COOLER (
) or COOLER (
) buttons at
)
25