Table of Contents
Advertisement
Operating
Controls
E E E E I E E I E E
4. OPERATIOil
4 - 1 .
e
VOL control/POWER sw¡tch
The volume control and power switch are combined.
Rotating the control clockwise will turn ON the
receiver.
Advancing the control further clockwise will increase
the volume.
SOL control
The SOL control is used to eliminate noise in the FM-N
mode during no signal periods. Normally this control is
adjusted clockwise until the noise just disappears, and
t h e B U S Y i n d i c a t o r ( S I G N A L r r - r ¡ - r i - r
) g o e s o f f .
This point is commonly know as the Squelch Threshold
point. For scan operat¡ons this control must be set to
the threshold point. When an incoming signal is weak
or unstable, readjust the SOL control for optimum
reception.
PHONE jack
Output terminal for earphone. The built-in speaker is
disabled when the earphone jack is inserted into this
jack. Use a subminiature plug.
VFO/M.ch (Memory channell key
This key is used to switch between the VFO and
Memory channel modes.
SGAN Key
This key is used to start and stop scanning.
MSG Key
This key is used to enter or recall a message.
@
@
@
@
@
l l
Advertisement
Table of Contents
