Table of Contents
Advertisement
REAR panel
@ nff
switch
@ Aruf I connector
@ anr 2 connector
DC power
connectof
VIDEO connector
(U.S.A. version)
The signal level from ANT 1 con-
nector is attenuated when this
switch is activated. When the
signal is very strong, the signal
should be attenuated to Prevent
distortion of the signal. Turn the
sw¡tch OFF when the signal is verY
weak.
This connector should be attached
to a suitable mobile antenna for
receiving.
This connector should be attached
to a suitable multi-band antenna or
single band antenna.
This connector is used to connect
the 13.8 VDC Power suPPlY.
This connector is used to connect a
television monitor to receive T'V.
@ nruf switch
@ LINE our
connectols
broadcasts, or to connect a VIDEO
tape recorder.
This switch is used to select the ap-
propriate antenna, ANT 1' AUTO
o r A N T 2 .
In AUTO Pos¡t¡on. the antenna ¡s
automatically selected as follows:
A N T 1 : A M 5 0 0 < f r e q u e n c y <
1 630 kHz
FM 87. 5 < frequencY <
1 O 8 . 1 M H z
ANT 2: OTHERS
These connectors are used to at-
tach the AUX connector or TUNE
connector of a STEREO receiver/
amplifire to receive stereo broad-
casts.
This jack is for connection of an ex-
ternal sPeaker.
@
o
t 4
@ exr. sP iack
Advertisement
Table of Contents
