Frequency Selection - Kenwood RZ-1 Instruction Manual

4-2. RECEIVER OPERATION
The Receiver will supply audio confirmation when a func-
tion is activated.
4-2-1. Reception
1. Connect the power supply and the antennas, and then
set the switches and controls as follows:
POWER (VOL) control : OFF (Fully counterclockwise)
POWER switch of the DC power supply(Fixed Station)
: O F F
: Fully counterclockwise
4. Rotate the Tuning control and select an open channel.
Then turn the SOL control clockwise until the noise
d i s a p p e a r s a n d t h e B U S Y i n d i c a t o r ( S I G N A L
-!::::ri:i
) goes OFF (Threshold point). (FM-N only)
5. Select the desired frequency when a signal is received.
the BUSY indicator will turn ON and S-meter will deflect.
6. To turn off the receiver, turn off the receiver's POWER
switch before you turn off the power supply, or if in a
vehicle, before you stop the engine.
4-2-2. Frequency Selection
Frequency can be changed in the VFO mode. The selected
frequencies can be stored in the Memory channels. (See
Memory Entry page 19.)
A. VFO mode
To select the desired operating frequency in the VFO mode
rotate the Tuning control, press the UP/DWN keys, or enter
the desired frequency directly by using the ENTER key and
numeric keys.
SOL control
2. Turn ON the DC power supply and then turn the
receiver's power switch ON. After a few second the
display panel will indicate as shown in Fig. I and some
control's and key's lights will turn on.
Note:
lf the display is not as shown Fig. 1 reset the microproces-
sor using the procedure in Sectk¡n ¿l-3-2 page 1g - 19.
3. Turn the VOL control clockwise until a signal or noise is
heard.
POWER (VOL) control
E I E ¡ T = I E E l E l E I E E @
i.i
E=
E
E
E I E ] E E E E I E E
t 5