Pro-Form ZT8 User Manual page 17

16. Note: If assembled on a smooth surface, the
treadmill may roll forward during this step.
Raise the Frame (56) to the upright position.
Important: Do not raise the Frame past the
vertical position. Have a second person hold
the Frame until step 18 is completed.
Orient the Latch Crossbar (38) as shown. Make
sure that the “"This side toward belt”" sticker
(C) is facing the treadmill. Attach the Latch
Crossbar to the brackets on the Frame (56) with
two 5/16" x 3/4" Screws (25) and two 5/16" Star
Washers (11).
17. Orient the Storage Latch (53) so that the decals
are facing away from the treadmill as shown.
Attach the lower end of the Storage Latch (53) to
the bracket on the Base (94) with an M8 x 42mm
Bolt (6) and an M8 Nut (12).
Raise the Storage Latch (53) to a vertical posi-
tion. If there is a tie in the top of the Latch,
remove and discard it.
16
Bracket
11
25
56
17
56
Decals
12
17
C
38
Bracket
11
25
Tie
53
94
6