Pro-Form ZT8 User Manual page 14

10. With the help of a second person, hold the con-
sole assembly near the Right Handrail (87).
See the inset drawing. Connect the Upright
Wire (81) to the console wire. The connectors
should slide together easily and snap into
place. If they do not, turn one connector and try
again. IF YOU DO NOT CONNECT THE CON-
NECTORS PROPERLY, THE CONSOLE MAY
BECOME DAMAGED WHEN YOU TURN ON
THE POWER. Remove the wire tie from the
Upright Wire.
11. Set the console assembly on the Handrails (86,
87). Be careful not to pinch any wires. Insert
the excess Upright Wire (81) into the Right
Handrail.
Attach the console assembly with six #8 x 1/2"
Screws (1), four 5/16" x 5/8" Screws (4), and
four 5/16" Star Washers (11). Start all ten
Screws, and then tighten them.
Tighten the four 5/16" x 1" Flat Head Screws
(28) and the two 5/16" x 1" Screws (8) (only
one side is shown).
10
Console
Assembly
Console
Wire
81
Wire Tie
11
81
87
11
4
8
28
1
1
14
Console
Wire
81
87
Console
Assembly
11
1
1
86
4