Samsung SND-560 User Manual page 37

Ch5. How to Operate Camera
3) Press the <SET> button.
4) Use the 4 direction buttons to move to a
desired letter and select the letter by pressing
the SET button. Repeat this to enter multiple
letters. You can enter up to 15 letters.
Notes
• If you move the cursor to CLR and press the <SET> button, all the letters are deleted. To edit a letter, change
the cursor to the bottom left arrow and press the <SET> button. Move the cursor over the letter to be edited,
move the cursor to the letter to be inserted and then press the <SET> button.
5) Enter a title, move the cursor to 'POS' and press the
<SET> button. The entered title appears on the screen.
Select the position to display the title on the screen by
using the 4 direction buttons and press the <SET>
button. When the position is determined, select 'END'
and press the <SET> button to return to the SPECIAL
menu.
• SYNC :
In areas where the supply is at 60Hz, you can synchronize
the output phase of multiple cameras using the power
synchronization function (Line-Lock) without using a
synchronization signal generator.
INT : Internal Synchronization Type
L/L : Power Synchronization Type, Line-lock
- Press the <SET> button.
- You can select a desired phase from 0 to 359 when select 'phase'.
- You can decide the synchronization between luminance and color signal when
select the 'mode'.
Notes
• When using AC power at 60Hz frequency, you can use the L/L type synchronization.
• When the power is DC 12V, the SYNC. menu is fixed to the 'INT' mode.
72
NETWORK CAMERA
CAM TITLE SETUP
A B C D E F G H I J K L M
N O P Q R S T U V W X Y Z
a b c d e f g h i j k l m
n o p q r s t u v w x y z
- . 0 1 2 3 4 5 6 7 8 9
← → C L R P O S E N D
FRONT DOOR
User's Manual
• MOTION DET
If you connect an alarm device to this camera, you can
monitor activity more efficiently, because a signal is
generated by the camera whenever motion is detected.
The motion detection signal is output through the MD
OUT port.
1) When the SPECIAL menu screen is displayed, press the
Up and Down buttons so that the arrow indicates MOTION DET .
2) Set up the mode using the 4 direction buttons.
- SENSITIVITY : You can select up to 8 MD areas. When SENSITIVITY number is high,
motion detection sensitivity is increased to recognize even small
movement.
- AREA MODE : Determines whether to use the MD area selected in SENSITIVITY.
- SEL POS : Determines which of the 4 vertices of each MD area is to be used.
- YPOS : Determines the coordinate of the vertical axis for SEL POS.
- XPOS : Determines the coordinate of the horizontal axis for SEL POS.
- FILL→SET : Fills in a selected MD area. Fills in a selected MD area. The color of filling
is sequentially selected as brown, orange, blue, cyan, yellowish green,
yellow and red.
- RETURN : Select this to save the MOTION DET menu settings and return to the
SPECIAL menu.
Notes
• MD areas show only MOTION DET menu. Therefore, MD areas don't display on the monitor screen.
• PRIVACY
Hide an area you want to hide on the screen.
1) When the SPECIAL menu screen is displayed, press the
Up and Down buttons so that the arrow indicates
'PRIVACY'.
2) Set up the mode using the 4 direction buttons.
- AREA SEL : You can select up to 8 MD areas.
NETWORK CAMERA
73
User's Manual