Sony SRW-5000 Operation Manual page 70

4-3 TC Menu
2
Press the [F3] (TCCONV MENU) button.
The TC CONVERT menu appears.
S T A R T I N G T C
00 00
H
J U M P I N G T C
03 00
T C
H
C O N V
o n
C U R R E N T T C
O R G T C
00 00
d i s p
H
o n
S T A R T S T A R T
T C P S T T C E N T T C S E L
STARTING TC: Time code used as a reference
when converting time code.
JUMPING TC: The loopback point for converting
time code with STARTING TC as the reference
point, and the conversion done in both forward
and reverse directions.
The time code is discontinuous at this point.
The following table shows an example of how the 25
frame time code is discontinuous when the operating
frequency is 25PsF, the playback tape is 24 frames,
and STARTING TC is 01:00:00:00, and 24F
JUMPING TC 22:00:00:00 (JUMP TC SEL=–3H).
24 Frames TC 25 Frames TC
JUMPING TC 22:00:00:00
:
01:00:01:01
Forward direction
01:00:01:00
M
:
STARTING TC 01:00:00:00
m
00:59:59:23
Reverse direction
:
22:00:00:01
JUMPING TC 22:00:00:00
3
If necessary, use the function buttons to change the
settings.
For details on the settings made by these buttons, see
the following table.
4-30
Chapter 4 Menu Settings
00 00
M S F
00 00
M S F
00 00
M S F
J U M P E X I T
+ 3 H
20:09:36:00
:
01:00:01:00
01:00:00:24
:
01:00:00:00
00:59:59:24
:
22:07:12:01
Non-consecutive
part
21:09:36:00
Indication
Button Function
[F3] TC CONV Specifies whether the time code
is converted to time code or not.
[F4] ORG TC DISP Specifies whether the time code
is displayed or not on two lines
in the HOME, TC, and PF
menus along with the converted
time code.
[F6] START TC Press to preset the STARTING
PST TC using the numeric buttons.
[F7]
START TC Press to enter the current time
ENT code as the STARTING TC.
[F8] JUMP TC SEL Selects the JUMPING TC as an
interval from STARTING TC.
Selectable values: –3H, –2H,
–1H, +1H, +2H, +3H, 0H
[F10]
EXIT Select to exit the TC CONVERT
menu.
To preset the 24F STARTING TC using the
numeric buttons
2 1
1
Press the TC button, and then press the ALT
button.
The ALT+TC menu appears.
2
Press the [F3] (TCCONV MENU) button.
The TC CONVERT menu appears.
3
Enter the time code in the data entry window with
the numeric buttons.
3
4