Item number
Item
631
ORIGINAL TC
display
JUMPING TC
632
select
Setting
Function
When item 630 is set to "on," this setting specifies whether
[off]
the 24-frame time code is displayed or not on the control
on
panel of the VTR before conversion.
off: The 24-frame time code is not displayed before
on: The 24-frame time code is displayed before conversion.
[---3H]
Sets the loopback point (JUMPING TC) for converting time
code with respect to the reference time code (STARTING
–2H
TC) for conversion.
–1H
–3H: The JUMPING TC is set 3 hours before STARTING
+1H
–2H: The JUMPING TC is set 2 hours before STARTING
+2H
+3H
–1H: The JUMPING TC is set 1 hour before STARTING TC.
+1H: The JUMPING TC is set 1 hour after STARTING TC.
0H
+2H: The JUMPING TC is set 2 hours after STARTING TC.
+3H: The JUMPING TC is set 3 hours after STARTING TC.
0H: The JUMPING TC is set 1 frame before STARTING TC.
conversion.
The type of time code displayed is specified by item 603.
TC.
TC.
A-33
Appendix