Sony SRW-5000 Operation Manual page 173

Menu List
Item number Item
626 DISPLAY
INFORMATION
select
627 CHAR WARNING
DISPLAY at dual
line mode
628 REMAIN TIME
DISPLAY
630
TC CONVERT
A-32
Appendix
Setting Function
time data & status When item 620 is set to "on", this setting specifies the
content of text information output from the MONITOR
time data & UB
connector of SD SDI OUT, the SD OUT COMPOSITE
time data & CTL
connector and FORMAT CONV. OUT (OPTION) connector.
time data & VITC
time data & status: Timer counter display and status
[time data only]
time data & UB: Timer counter display and user bits.
time data & CTL: Timer counter display and CTL.
time data & VITC: Timer counter display and VITC.
time data only: Timer counter display only.
[off]
When item 626 is set to anything other than "time data
on only", this item specifies whether warning messages flash
on the second line or not.
off: Warning messages do not flash.
on: If a warning message exists, it flashes.
Notes
• Messages that have been cleared are not displayed.
For more information about clearing warning messages,
see "Clearing warning messages" on page A-9.
• When there are multiple warning messages, each
message flashes twice before it is replaced by the next
message.
[off]
Sets whether to display remaining time on the tape in
10min superimposed character position.
on
off: Do not display remaining time.
10 min: Display remaining time when it is 10 minutes or
on: Always display remaining time.
Note
The remaining time on the tape is not displayed when no
cassette is inserted. The remaining time is not also
displayed until the VTR finishes detecting the diameter of
the wound tape and estimating the remaining time
immediately after the cassette is inserted.
Selects whether to convert the playback time code to the
[off]
operating frequency time code when tapes recorded with
on
different frame rates are used for off-speed playback.
off: Does not convert the time code.
on: Converts the time code.
information.
less.
(Continued)