Sony SRW-5000 Operation Manual page 176

Item number Item
742 CHROMA PHASE
(HD/UC/SD/DC)
preset: 0
755 MASTER LEVEL
(D1)
preset: 100%
(4000H)
756
Y LEVEL (D1)
preset: 100%
(4000H)
757
B–Y LEVEL (D1)
preset: 100%
(4000H)
758 R–Y LEVEL (D1)
preset: 100%
(4000H)
762 SETUP LEVEL
(CST)
preset: 7.5 IRE
763 SYNC PHASE (SD)
preset: 0
764 FINE (SD)
preset: 0
775 VIDEO OUTPUT
DATA
776 DOWNCONVERTER
INPUT CHECK
ENABLE
Setting Function
–127 Adjusts the chroma phase (HUE) of HD, UC, SD, and DC output.
. . .
0
. . .
127
0.0% (0H) Adjusts the level of the high D1 video signal output from SD SDI
. . .
OUT and FORMAT CONV. OUT (OPTION) connectors.
Simultaneously adjusts the Y, B–Y, and R–Y level.
100 % (4000H)
. . .
141.3% (5A70H)
0.0% (0H) Adjusts the level of the D1 video signal output from SD SDI OUT
. . .
and FORMAT CONV. OUT (OPTION) connectors.
Simultaneously adjusts the Y levels.
100 % (4000H)
. . .
141.3% (5A70H)
0.0% (0H) Adjusts the level of the D1 video signal output from SD SDI OUT
. . .
and FORMAT CONV. OUT (OPTION) connectors. Adjusts the
B–Y level of the video signal.
100 % (4000H)
. . .
141.3% (5A70H)
0.0% (0H) Adjusts the level of the D1 video signal output from SD SDI OUT
. . .
and FORMAT CONV. OUT (OPTION) connectors. Adjusts the
R–Y level of the video signal.
100 % (4000H)
. . .
141.3% (5A70H)
0.0 Adjusts the setup level of the analog composite video signal
. . .
output from SD OUT COMPOSITE (MONITOR) connector.
[7.5]
. . .
10.0
–128 Adjusts the sync phase of the D1 video signal output from SD
. . .
SDI OUT and FORMAT CONV. OUT (OPTION) connectors and
[0]
analog composite video signal output from SD OUT
. . .
COMPOSITE (MONITOR) connector.
127
Makes fine adjustments to the sync phase of the D1 video signal
[0]
. . .
output from SD SDI OUT and FORMAT CONV. OUT (OPTION)
connectors and analog composite video signal output from SD
1024
OUT COMPOSITE (MONITOR) connector.
8bit Sets the bit size of the output data from the HD-SD converter.
8bit: When connected to an 8-bit system
[10bit]
10bit: When connected to a 10-bit system
Notes
• Make sure the bit length matches the destination device.
• This setting is only active when the HD-SD converter output is
set to D1.
[disable] Selects the HD-SD converter mode when the INPUT CHECK
button on the control panel is pressed.
enable
disable: The INPUT CHECK button is not linked to HD-SD
converter output.
enable: The INPUT CHECK button is linked to HD-SD converter
output.
Note
The INPUT CHECK button works for all of the HD-SD converter
output connectors.
(Continued)
A-35
Appendix