Insert Stove Installation & Operating Instructions; General; Handling; Fire Cement - Stanley Cara Installation And Operating Instructions Manual

INSERT STOVE INSTALLATION & OPERATING INSTRUCTIONS
NOTE: Please note that it is a legal requirement
under England & Wales Building Regulations that
the installation of the stove is either carried out
under Local Authority Building Control approval or
is installed by a Competent Person registered with
a Government approved Competent Persons
Scheme. HETAS Ltd operate such a Scheme and
a listing of their Registered Competent Persons
can be found on their website at www.hetas.co.uk.

GENERAL

This insert is suitable for a standard 16" or 18" wide
by 22" high fireplace opening, it is also suitable for
most cast iron curved top fireplaces when used with
our curved backing plate, this is available as an
optional extra, see details in this manual.
When installing, operating and maintaining your
stove respect basic standards of fire safety. Read
these instructions carefully before commencing the
installation. Failure to do so may result in damage to
persons or property. Consult your local Municipal
office and your insurance representative to deter-
mine what regulations are in force. Save these
instructions for future reference.
Special care must be taken when installing the stove
such that the requirements of the Health & Safety at
Work Act are met.

Handling

Adequate facilities must be available for loading,
unloading and site handling.

Fire Cement

Some types of fire cement are caustic and should
not be allowed to come into contact with the skin. In
case of contact with the skin wash immediately with
plenty of water.

Asbestos

This stove contains no asbestos. If there is a possi-
bility of disturbing any asbestos in the course of
installation then please seek guidance and use
appropriate protective equipment.

Metal Parts

When installing or servicing this stove care should
be taken to avoid the possibility of personal injury.
IMPORTANT WARNING: This stove must not be
installed into a chimney that serves any other
heating appliance.
The installation must be completed in
accordance with
European Standards and Local Codes. It
should be noted that the requirements and
these publications may be superseded during
the life of this manual.
PRE-INSTALLATION
After removing the stove from the packaging, open
the fire door and remove the loose packing. Prior to
installation all the internal components of the stove
are removed to gain access to fixings and to make it
lighter for installation.
Remove the refractory fire bricks, these bricks are
loose and just need to be lifted clear of the grate
support plate before they can be removed.
To remove the loose baffle, lift the front edge until it
hits the top and then slide it forward. Then drop the
rear edge and the baffle will slide down.
To remove the fixed baffle, loosen the two roof bolts,
support the baffle with one hand while removing the
L shaped brackets with the other hand, see Fig.1.
Fig.1
This will allow the baffle to drop down clear of the
roof bolts. The baffle will then slide back and down
to allow it to be removed from the stove, see
Fig.2A&B.
Fig.2A
2
current National and