Rotation Control Switch - Henny Penny SCR-6 Technical Manual

2-7. DRIVE MOTOR
REPLACEMENT KIT
(Continued)
Step 6
Step 8
Step 11
2-8. ROTATION CONTROL
SWITCH
2-6
6. Slide extension hub (on motor) into slot on the unit, and
bolt the motor to the bracket. Snug, but don't tighten nuts.
7. Install discs into unit and place rod into place.
8. Adjust motor on bracket so no more than 1/16" (1.6 mm) gap
is present and the end of the rod is even all around hub.
The rod must not have much "play" in it from the disc
hub. The gap between the end of the rod and the hub
should not be more than 1/16" (1.6 mm) or damage to
rod and disc assembly could occur.
9. Once rod is lined up, tighten nuts on bracket.
10. Splice wires of motor onto the cut wires, according to colors.
11. Remove wires to the drive motor capacitor , mounted under
the motor. Remove the capacitor from the unit and replace
with the one in the kit.
12. Replace side panel and restore power .
1. Remove electrical power supplied to unit.
To avoid electrical shock or property damage, move the
power switch to OFF and disconnect main circuit
breaker, or unplug cord at wall receptacle.
SCR-6/8
1207