Heat & Glo SL350TRSI-N-CE Owner's Manual page 2

MODELS: SL350TRSI-N-CE, SL350TRSI-PB-
CE ARE BSI APPROVED FOR NATURAL GAS,
PROPANE OR BUTANE AS A BALANCED FLUE
FIREPLACE.
Refer to the appliance data plates for gas con-
sumptions and pressures.
Installation of this appliance should only be
carried out by an authorized person in accor-
dance with the manufacturer's instructions.
Appliance is to be installed in full compliance
with the manufacturer's instructions, and any
local authorities' requirements for gas, electrical
and building regulations.
This appliance and its components are tested
and safe when installed in accordance with this
Installation Manual. Report to your dealer any
parts damaged in shipment, specifically check
glass condition. The gas logs and flue system
components are in separate packages. Read
all instructions before starting installation and
follow these instructions carefully during instal-
lation to ensure maximum benefit and safety.
Heat & Glo, a brand of Hearth & Home Technologies
7571 215 Street West, Lakeville, MN 55044
th
Copyright 2013 • Printed in U.S.A.
2
PLEASE READ THIS MANUAL BEFORE INSTALLING
AND USING THIS APPLIANCE.
It is the responsibility of the professionals involved with the service
and installation of the appliance to test the operation of the appliance
before leaving the installation site.
IMPORTANT: Read all instructions carefully before starting installation.
Failure to follow these installation instructions may result in a possible fire
hazard and will void the warranty. Save this manual for future reference.
Heat & Glo • SL350TRSI-N-CE, SL350TRSI-PB-CE • 2033-980 Rev. J • 3/13
Failure to follow them will void your warranty
and may present a fire hazard.
The Heat & Glo, a brand of Hearth & Home
Technologies Inc. warranty will be voided by,
and Heat & Glo, a brand of Hearth & Home
Technologies Inc. disclaims any responsibility
for the following actions:
• Installation of any damaged fireplace or flue
system component
• Modification of the fireplace or balanced flue
system installation other than as instructed
by Heat & Glo, a brand of Hearth & Home
Technologies
• Improper positioning of the gas logs or the
glass door
• Installation and/or use of any component part
not manufactured or approved by Heat &
Glo, brand of Hearth & Home Technologies,
not withstanding any independent testing
laboratory or other party approval of such
component part or accessory.