Table of Contents
Advertisement
INSTALLATION
Connecting the HoTelephone (Models 3910s and 3810X)
Connecting this HoTelephone to a telephone company line must be
through a universal service order code (USOC) outlet jack. The
USOC jack code numbers are:
l
Single-line desk telephone = RJl 1 C
l
Single-line wall telephone = RJl 1 W
If the installation site doesn't have the proper jack(s) and inside
wiring, it is the user or installer's responsibility to arrange for their
installation. The correct outlet jack for this equipment is an in-
dustry-standard type 625A2-6 jack wired per the USOC jack code
number.
Local telephone company regulations may not permit connections
to party lines and coin lines by anyone except the telephone operat-
ing company.
Preparing the HoTelephone for Wall Mounting
This telephone is shipped from the factory configured for desk use.
To convert from a standard desk model to one that can be hung on
the wall, follow the procedure outlined below.
1. Disconnect line cord from telephone.
2. Turn telephone over to expose lower housing.
(1
The telephone
circuitry
is sensitive
to static
electricity
discharge.
Be sure that your body
and the work place are properly
grounded
to
avoid
any static
electricity
discharge
while
step 3 is being performed.
3. Remove screws that attach lower housing to upper housing.
Carefully separate lower and upper housings making sure
not to disconnect wiring between the two housings.
4. This telephone is equipped with a data/auxiliary port.
l
Remove hole cover from new opening that auxiliary jack
is to occupy.
Continued
on next page...
Advertisement
Table of Contents
