Speakerphone Operation; Answering A Call Using The Speakerphone; Making A Call Using The Speakerphone; Switching Between Speakerphone And Handset During A Call - Comdial HoTelephone 3910S User Manual

SPEAKERPHONE OPERATION
(Model 3910s Only)
When you make or answer a call, you can have a conversation
without using the telephone handset, or handsfree, because a
microphone and speaker are built into the telephone set. The
microphone port is located in the front right-hand edge of the
telephone housing. To make sure the speakerphone operates
properly, check to see that this port is not blocked by any obstruc-
tions.
Answering a Call Using the Speakerphone
1. When the telephone rings, press the SPKR button. The
light above the speakerphone on/off button will turn on to
indicate that speakerphone is active.
2. Speak in normal tone of voice toward telephone.
3. If needed, adjust loudness of caller's voice With volume
control located in front edge of telephone (Figure 2).
4. End speakerphone call by pressing SPKR button again.
Light will turn off and telephone will hang up.
Making a Call Using the Speakerphone
1. Press SPKR button. Note that light turns on to indicate
speakerphone is active.
2. When dial tone is heard over speaker, dial desired number.
3. End speakerphone call by pressing SPKR button again.
Light will turn off and telephone will return to idle state.
Switching Between Speakerphone and Handset During
a Call
Speakerphone to handset,
1. Lift handset from cradle.
2. Continue in-progress call with handset.
3. Hang up handset to end call.
Continued on next page