Samsung HG690 Installation Manual page 60

SIRCH operating Diagram
TCP/IP
(Windows
Remote
Access)
SIRCH Installation Considerations
There are a number of factors and operations you need to consider when you set up and run SIRCH:
1. Set the SIRCH Update Time
– Under normal conditions, use Standby SIRCH. Standby SIRCH updates TVs when they have been in Standby mode for a
certain length of time or when they are in Standby mode at a certain time every day.
– You can set the standby SIRCH value to Off, 1Hour, 2Hour, 12:00 PM, 02:00 PM, 12:00 AM, or 02:00 AM.
– The default value is 1Hour.
– When you select "1Hour" or "2Hour", 1 or 2 hours after a TV goes into Standby mode, the SIRCH upgrade starts
automatically.
– If you select a specific time setting, the Standby SIRCH is performed once a day at the defined time.
2. Set the SIRCH Channel
– Use SIRCH Channel to set the PID frequency that willl carry the SIRCH parameters to the TVs in the system.
– Open Cable : You can use CH2 through CH135.
– A detailed frequency table is available in the SIRCH Windows Application Program User's Manual.
3. Verify the SIRCH Version
– The SIRCH version at the headend must be a higher version than the version on the TVs for the TVs to update.
– For example, if the software version in the SIRCH PC application is 01a0, then the current TV SIRCH version on a TV must be
less than this for the TV to update.
– The software version value updates to a higher value automatically each time a change is implemented.
– The software version value for the TV clone data must be in hexadecimal format.
4. Test using Manual SIRCH
– Plan to use Manual SIRCH to test whether SIRCH has been installed properly.
NOTE
Please visit www.lumantek.com/sirch/ for more information.
SIRCH Windows Application Program User's Manual is available at http://www.samsung.com/us/business/
hospitality.
60
English
[HG690_EURO]Install_Guide-00ENG.indd 60
Hotel Installer can edit the Install Menu/
Channel Map data using the SIRCH
windows application program.
Coax.
RF
Cable
You can updated all hospitality TVs in an
entire installation.
This includes delivering TV firmware,
channel mapping, and settings.
2013-03-21 4:37:03