Samsung HG690 Installation Manual page 31

¦
Multi Code Remocon
Multi Code Remocon is a special transmitter which is designed to control each TV with one remote.
This is useful where there is more than one TV in a location, such as in a hospital the set ID number is displayed in the
source osd. It is possible to support up to 9 different remote key transmissions for multiple codes.
Each TV has an inital code of "0".
– The ID code can be set and reset in Analog TV mode or PC mode. (not available in TTX channel or DTV channel.
– ID codecan be from 0 to 9.
– Press the Blue Key for over 7 seconds and then select the number button to set the code.
– Set ID OSD appears.
– The following words appear: "Remote control code is set to x. If you want to change Remote control code.
Enter the digit you want to change." X is the digit number This OSD displays until Exit is pressed.
Remote control code is set to 0. If you want
to change the Remote control code, enter the
chosen digit.
– For example, TV and Remote will be set to ID code #1 if the user presses #1.
– The following words appera: "Remote control code is changed to 1" At this point, the TV can be controlled only
by the remote with the same ID code as the TV.
– TV, the following words will be displayed. " TV ID x"(x is the TV's ID)
– To reset the ID code, press the Yellow key for over 3 seconds. the ID code for both the TV and Remote are reset
to "0". "Remote control code is set to 0." appears.
[HG690_EURO]Install_Guide-00ENG.indd 31
31
English
2013-03-21 4:37:00