Table of Contents
Advertisement
9. Turn the power on and make sure the added memory is recognized. Open
System Properties in the Control Panel and click the General tab.
NOTE: When you view the memory display, the total amount will be
reduced by 16 MB, which is used for VRAM.
Removing memory module
To remove the memory module, make sure the computer is in boot mode then:
1. Turn the computer off and remove all cables connected to the computer.
CAUTION: Do not remove the memory module while the computer is in
standby mode. The computer could hang up the next time you turn it on
and data in memory will be lost. In either of the above cases, the standby
configuration will not be saved.
The following message appears when you turn on the power:
WARNING: RESUME FAILURE.
PRESS ANY KEY TO CONTINUE.
If the computer hangs up when you turn it on, perform the following:
Press the power button and hold it down for five seconds, then turn the
power on again.
2. Turn the computer upside down and remove the Battery Pack (refer to
Chapter 6,
Power and Power-Up
3. Remove two screws securing the memory module cover.
4. Lift off the cover.
5. Remove one screw.
Memory expansion
Modes.)
8-9
Advertisement
Table of Contents
