GBC HeatSeal Sprint H925 Instruction Manual page 5

HeatSeal Sprint H925 - Load Film from Empty
®
Caution, hot surfaces.
Start
8
TM
Use instructions below to load new film if completely empty.
STEP 1
First, complete steps 2, 3 and 4
from "Load Film" page 7. Close 4
EZload levers.
STEP 2
Press Feed switch (forward) and
insert the threading card (supplied
with EZload film) as shown. Insert
card with slight force through film
rollers.
STEP 3
Insert idler bar assembly. Continue
pressing feed switch and wait for
clear, wrinkle-free lamination.
STEP 4
Close top cover, select film
thickness.
Stop
3 mil / 75 mic 5 mil / 125 mic
(Film Select)
HeatSeal Sprint H925 - Alert Indicators
® TM
Do not take machine apart - No user servicable parts.
(Alert LED)
Start Stop
3 mil / 75 mic 5 mil / 125 mic
(Low Film LED)
Start Stop
3 mil / 75 mic 5 mil / 125 mic
TOP COVER ALERT
Top cover is open. Close the cover
and resume lamination.
LOW FILM ALERT
Open top cover and load new
film rolls. Refer to "Load Film",
pg. 7 and 8.
9