Installation Location - Toshiba RAS-07PKVP-E Service Manual

High Wall, Heat Pump Type
9-3. Installation of Indoor
Unit

9-3-1. Installation Location

• A place which provides enough space around the
indoor unit as shown in the diagram.
• A place where there are no obstacles near the air
inlet and outlet.
• A place which allows easy installation of the piping to
the outdoor unit.
• A place which allows the front panel to be opened.
• The indoor unit shall be installed so that the top of the
indoor unit is positioned at least two m high.
Also, avoid putting anything on the top of the indoor
unit.
Remote controller
• Should be placed where there are no obstacles,
such as curtains, that may block the signal.
• Do not install the remote controller in a place
exposed to direct sunlight or close to a heating
source, such as a stove.
• Keep the remote controller at least 1 m away from
the nearest TV set or stereo equipment. (This is
necessary to prevent image disturbance or noise
interference.)
• Do not install near high-frequency devices or
wireless devices.
• The location of the remote controller should be
determined as shown below.
(Side view)
(Top view)
Indoor unit
Remote
Reception
controller
range
*: Axial distance
9-3-2. Drilling and Mounting
Installation Plate
Drilling
When installing the refrigerant pipes from the rear.
150 mm from
unit edge
100 mm to pipe
hole center
100 mm
Reception
Remote controller
range
Dia. 80 mm
Pipe
hole
45 mm
1) Decide the installation plate mounting position
on the wall.
2) Mark the corresponding pipe hole wall
positions according to the positioning marks (
) on the installation plate.
3) Drill the pipe holes (Dia. 65 mm or Dia. 80 mm)
slightly slanted downward to the outside.
NOTE
• When drilling into a wall that contains a metal lath,
wire lath or metal plate, be sure to use a pipe hole
brim ring sold separately.
• The unit is designed to enable installation using
holes of 65 mm in diameter. However, if installation
is difficult, make holes that are 80 mm in diameter.
Completely fill in the gaps in the pipe holes with
noncombustible material (such as putty) to prevent
condensation and fire in the casing.
Mounting the installation plate
Positions recommended for
securing the screws (4 places)
Anchor bolt holes
Level (magnetic-backed)
holder
Pipe hole
Indoor unit
Mounting the installation plate directly on a
wall
1) Securely fit the installation plate onto the wall
by screws with the upper and lower catches.
2) To mount the installation plate on a concrete
wall use anchor bolts. Drill the anchor bolt
holes as illustrated in the above figure.
3) Place the level at the top end of the installation
plate, and check that the plate is horizontal.
When installing the installation plate with mounting
screws, do not use anchor bolt holes. Otherwise the unit
may fall down and result in personal injury and property
damage.
60
Service Manual
CAUTION
[1] Installation plate
Pipe hole
[5] Mounting screw
CAUTION