Name And Functions Of Indications On Remote Controller - Toshiba RAS-07PKVP-E Service Manual

High Wall, Heat Pump Type

8-22-2. Name and Functions of Indications on Remote Controller

Display
All indications, except for the clock time indicator, are displayed by pushing the
1
2
3 4
AUT UTO
9 7 5
• In the illustration, all indications are shown for
purposes of explanation.
During operation, only the relevant indicators are
shown on the remote controller.
1
Transmission mark
This transmission mark (
controller transmits signals to the indoor unit.
2
Mode indicator
Indicates the current operation mode.
• Heat pump models
(AUTO : Automatic control, A : Auto change
over control, : Cool,
3
Temperature indicator
Indicates the temperature setting. (17°C to 30°C)
4
PURE indicator
Shows that the electrical air purifying operation is in
progress.
5
FAN speed indicator
Indicates the selected fan speed. AUTO or five fan
speed levels (LOW
MED+ , HIGH
Indicates AUTO when the operating mode is either
AUTO or : Dry.
6
TIMER and clock time indicator
The time setting for timer operation or the clock time is
indicated.
The current time is always indicated except during
TIMER operation.
7
Hi POWER indicator
Indicates when Hi POWER operation starts.
Press the Hi POWER button to start and press it again
to stop operation.
10
8
6
) indicates when the remote
: Dry, : Heat)
, LOW+ , MED
) can be shown.
8
(MEMORY) indicator
Flashes for 3 seconds when the MEMO button is
pressed during operation.
The mark is shown when holding down the button for
3 seconds or more while the mark is flashing.
Press another button to turn off the mark.
9
SLEEP MODE indicator
Indicates when the SLEEP MODE is activated.
Press the SLEEP MODE button to start and press it
again to stop operation.
10
A, B change indicator remote controller
• When the remote controller switching function is
set, "B" appears in the remote controller display.
(When the remote controller setting is "A", there
is no indication at this position.)
NOTE
Remote controller switching function
• If two indoor units are installed in the same room or
adjoining rooms, both units may start and stop at
the same time when the remote controller is
operated. This can be prevented by setting the
switching function so that each indoor unit is
operated only by the corresponding remote
controller.
• To use the remote controller switching function,
refer to 8-16.
,
55
Service Manual
button.