Maintaining Your Heater's Appearance; Accent Light Replacement; Lower Accent Lights; Upper Accent Lights - Travis Industries 616 GSR2 Insert Owner's Manual

40
DANGER HIGH VOLTAGE: Disconnect power before attempting maintenance or repair.

Maintaining Your Heater's Appearance

Fingerprints or other marks left on the optional plated surface may become etched in place if they are not
wiped clean prior to turning the heater on. Clean the plated surfaces with denatured alcohol and a soft
cloth (with the heater cool). Other cleaners may leave a film that may become etched into the surface.

Accent Light Replacement

The accent lights in your heater provide additional lighting. The bulbs will burn out over time. To replace,
follow the directions below:

Shut off gas to the heater and let it cool for 15 minutes.

Remove the glass (see page 22) and media.

Replace the halogen bulbs with the following bulbs:
NOTE: Take care to not touch the bulbs with your fingers – use foam packing or a paper towel to
handle the bulbs:

Lower Accent Lights

The lower accent lights are located at the back of the firebox behind the light deflector as shown below.
They can be removed by pulling them out.

Upper Accent Lights

The upper accent light can be accessed by removing the 4 screws with a ¼" nutdriver, as shown below.
© Travis Industries
Maintenance
35 Watt 120 Volt T4 Halogen Bulb (G6.35 Base)
4140808 100-01298