Table of Contents
Advertisement
38
DANGER HIGH VOLTAGE: Disconnect power before attempting maintenance or repair.
Maintaining Your Heater's Appearance
Fingerprints or other marks left on the optional plated surface may become etched in place if they are not
wiped clean prior to turning the heater on. Clean the plated surfaces with denatured alcohol and a soft
cloth (with the heater cool). Other cleaners may leave a film that may become etched into the surface.
Accent Light Replacement
The accent lights in your heater provide additional lighting. The bulbs will burn out over time. To replace,
follow the directions below:
1. Shut off gas to the heater and let it cool for 15 minutes.
2. Remove the glass (see page 21) and media.
3. Replace the halogen bulbs with the following bulbs:
NOTE: Take care to not touch the bulbs with your fingers – use foam packing or a paper towel to
handle the bulbs:
Upper Accent Lights
The upper accent light can be accessed by removing the 4 screws with a ¼" nut driver, as shown below.
The upper accent light assembly drops down to expose the accent light.
When replacing the assembly, carefully insert the wiring into this cavity to ensure the wiring is
not pinched.
The upper accent light may now be accessed.
© Travis Industries
Maintenance
35 Watt 120 Volt T4 Halogen Bulb (GY6.35 Base)
5/20/2021 - 1558
430 MF GSR2
Advertisement
Table of Contents
